The idea is a static body VTOL design that can hover stable in the air, and also go at high speeds very efficiently with wings. Could modify dimensions as needed, but general idea, I’m unsure if there’s a major design issue?
The idea is a static body VTOL design that can hover stable in the air, and also go at high speeds very efficiently with wings. Could modify dimensions as needed, but general idea, I’m unsure if there’s a major design issue?
Yea but don’t the flat rotors cause drag? The point being, the rotor inside the wing is not causing drag.
It would absolutely cause drag, just not from the wing’s leading edge but from wake turbulence added to the air flow that’s still going over the wing.
Probably not as much as having an exposed rotor, also maybe you could angle the edge of the hole so the air flows over it like a ramp.
Probably, maybe, possibly, perhaps. All fun words. Having a hole in the wing is probably way worse than some windage. It cuts the balls out of the laminar flow and pressure differential. I’m no pilot, but as a sailor I can tell you that sails do not perform very well with holes in them.
Why not make the little ramp at the front of the wing so the air flows over it like a ramp and then you can do away with the entire rest of the wing?
Indeed, you clearly know what you’re talking about. A little ramp at the front of the wing would help, with a divet on the other side of the hole to smooth the air flowing down into the other side.